KiwiGrip anti-slip marine deck coating is a revolutionary, safe, durable, non-skid deck treatment that comes out of the can with a thick, yogurt-like, consistency — but spreads quickly and easily with our proprietary roller. KiwiGrip offers a beautiful, consistent, grippy surface. By varying the application technique, the texture can be adjusted from “fine” to “aggressive.”
What’s so special about KiwiGrip?
Unlike other marine anti-skid deck coatings, KiwiGrip was developed by a New Zealand yachtsman for yachtsmen. It’s not just another industrial product stumbling upon a marine application.
KiwiGrip is . . .
A very hard acrylic polymer providing a durable, homogeneous, elastic anti-skid surface
Low-glare, IR reflective finish
Homogeneous color – won’t wearthrough and expose filler materials
Available in white, cream, light grey,
light green and light blue
Dial in the perfect texture for your application with
our special roller (included with order)
Apply over wood, fiberglass, epoxy, concrete, or metal
(following proper primers)
Rolls on nicely over other worn non-skid
surfaces with only a scrub and scuff-up —
no need to grind or sand smooth first
No toxic solvents or cleansers
needed to prepare surface
Cleans up with soap and water
Complete, detailed “how-to” instructions
included with each order
KiwiGrip is a homogenous material, so it doesn’t present the problems encountered with products filled with sand, walnut shells, beads, rubber fleck, or other fillers. Anti-skid coatings with fillers tend to wear through, and the fillers fall out — leaving an unsafe deck that’s hard to clean and even harder to re-coat. With Kiwigrip, re-coating is a breeze, and repairs are invisible.
KiwiGrip is applied by brush and our special texture roller, and so is considerably easier, faster and less expensive to apply than spray or two-part anti-slip deck coatings.
Coverage: 2 square meters per liter (approximately 80 SF/Gal).
|
|
|
1.Masking off the edge |
2.Spreading with roller |
 |
|
|
3.Peel tape while still wet |